Baby Lock Jewel BL J18 Instruction Manual download pdf (Page 16)

Installing the

Power Cord

NOTE: Please make sure that the machine is

in the “O” or o position before plugging

into power source.

Insert the cord into the top power connector on

the rear of the machine. Plug the three-prong end

into power source (Figure 9).

e lower power connector is for powering other

attachments. (For future development)

Figure9

Power

Eyelets

Figure10

Installing the

Thread Mast

Locate the threaded hole on top of the machine

near the rear by the handwheel. e thread mast

comes with the washer and nut on it. Remove the

nut and washer, replace the nut onto the mast and

then place the washer under the nut and onto the

machine painted surface. e washer protects the

painted surface when the nut is tightened. Tighten

the mast clockwise until it is securely in place. Use

the nut to secure the mast to the machine.

NOTE: e eyelets of the thread mast must

be centered over the spool pins—so the cone

will not pull, turn or tilt, causing thread

tension problems (Figure 10).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 45 46

No comments

Baby Lock Jewel BL J18 Instruction Manual Page 16