Baby Lock Cover Stitch BLCS-2 Instruction Manual download pdf (Page 35)

1. Open the front cover and raise the presser foot.

2. At the threading port, cut the chain looper thread. Remove

chain looper thread from under the presser foot and the upper

thread guides. Replace cone of thread with specialty thread.

3. Place the machine in "locked" position to thread the chain

looper.

4. Thread specialty thread into the upper thread guides, leaving

an 18inch (40cm) tail above the threading port.

5. Place the straight end of the looper threading tool into the

threading port. Push the looper threading tool until the end

comes out of the looper eye. Open side door of machine to

see threading tool come out of the eye of chain looper.

6. Insert the specialty thread tail into the looper threading tool

eye (fig.A). Pull the straight end of the looper threading tool

through the looper eye bringing the specialty thread with it.

(fig.B)

7. Cut chain looper thread to 4 inches (10cm) and place in tray.

Close the side door of the machine.

Looper Threading Tool

★New_BLCS-2 Ta:BLCS-2 En.qxd 2009/05/25 16:59 ページ 33

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

No comments

Baby Lock Cover Stitch BLCS-2 Instruction Manual Page 35