Baby Lock Aria BLAR Instruction Manual Page 44

  • Download
  • Add to my manuals
  • Print
  • Page
    / 200
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 43
UPPER THREADING
B-42
Using the Twin Needle Mode
The twin needle can only be used for patterns that
show after being selected. Before you select a
stitch pattern, make sure the stitch can be sewn in
the twin needle mode (refer to the “STITCH
SETTING CHART” on page S-68).
a
Press to lock all keys and buttons
and install the twin needle (CHANGING
THE NEEDLE” on page B-47).
b
Thread the machine for the first needle
according to the procedure for threading a
single needle (“Upper Threading” on
page B-38).
c
Pass the thread through the needle bar
thread guides on the needle bar, then
thread the needle on the left side manually.
a Needle bar thread guide
d
Pull up the supplemental spool pin and set it
in the up position.
a Supplemental spool pin
CAUTION
Twin needle (part code X59296-151) is
recommended for this machine. Contact your
authorized retailer for replacement needles
(size 2.0/11 is recommended).
Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
Do not sew with bent needles. The needle
could break and cause injury.
When using the twin needle, it is
recommended to use presser foot “J”.
When the twin needle is used, bunched
stitches may occur depending on the types of
fabric and thread that are used.
Use monogramming foot “N” for decorative
stitches.
Before changing the needle or threading the
machine, be sure to press
on the LCD
screen to lock all keys and buttons, otherwise
injuries may occur if the “Start/Stop” button
or any other button is pressed and the machine
starts sewing.
Note
The “Automatic Threading” button cannot
be used. Manually thread the twin needle
from front to back. Using the “Automatic
Threading” button may result in damage to
the machine.
Page view 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 199 200

Comments to this Manuals

No comments