Baby Lock Jewel BL J18 Instruction Manual Page 37

  • Download
  • Add to my manuals
  • Print
  • Page
    / 46
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 36
34
Troubleshooting continued
HOPPING
FOOT WON’T
CLEAR SEAMS
THREAD NESTS
UNDER QUILT
MOTOR FAILS
TO RUN
UNEVEN QUILT
DESIGN
IRREGULAR
STITCHES
•Decreasethepressureonthehoppingfootbylooseningthenutat
the base of the hopping foot sha. Adjust to the proper height.
IMPORTANT NOTE: When tightening the nut on the hopping
foot sha be careful not to tighten so tight that it rotates the
bar. Remember to readjust back to normal height aer quilting
the thick quilt. Take note of how many times you rotated the
foot up to accommodate the thick quilt. When nished,
rotate the foot back down the same number of times to bring
it back to the optimum setting.
•Checkthatthemachineisthreadedcorrectly.Makecertainthat
thread is “ossed” snugly in place between the two tension discs. If
machine is threaded correctly, tighten top tension by rotating the
tension knob clockwise.
•Refertothreadingdiagramandthreadinginstructions(page 16).
•Turnthemachineonbyusingtheswitchonthebackelectrical
control cover.
•Checkthatthepowerconnectorispluggedintothebackofthe
machine and the three-prong end is plugged into power source
•Makecertainthatthefabricisnotrolledtootight,causingthe
fabric to stretch. Check that poles overlap and snap together with the
snap button so bowing wont occur.
Iffabricisbeginningtostretchorfray,contactyourauthorizedBaby
Lock retailer for replacement leaders.
•Checkthatallcablesareconnectedtightly.
Problem Cause Correction
Quilt sandwich is too
thick (i.e. denim with
thick batting)
Not enough tension on
top thread
Improper threading
On/O switch turned
o
Machine not receiving
power
Take-up rollers may be
bowed or bent
Leaders are stretched/
worn
Long and short stitches
in Regulated Stitch
Mode
Page view 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 45 46

Comments to this Manuals

No comments