Baby Lock Enlighten BLE3ATW-2 Instruction Manual download pdf (Page 45)

Thread Cradle for Loopers

1. Open the front cover and raise the presser foot.

2. At the threading port, clip the looper thread that is to be replaced.

(fig.A) Remove thread from under the foot and the upper thread

guides. Replace cone of thread with specialty thread.

3. With

the threading lever engaged in the threading position (fig. B)

turn handwheel towards you to close looper tubes (fig. C).

4. Thread specialty thread into the upper thread guides, leaving an

18 inch (40cm) tail above the threading port (fig.D).

5. Cut a 24 inch (55cm) strand of serger thread and fold in half to

form a thread cradle. Insert the loose ends of the thread cradle

into the port about 1 inch (2.5cm).

6. Holding the cradle loop with your left hand, depress the "Push to

Thread" Button with your right hand (fig.E) until the thread ends

come out the looper eye. For chain looper, open side door of

machine to make sure thread is in eye of chain looper.

7. Insert the specialty thread tail into the cradle loop (fig.F), pull the

serger thread ends until the specialty thread comes through the

looper eye (fig.G). Discard or set aside the thread cradle.

8. Run upper looper thread under the foot and to the left, cut lower

looper thread to 4 inches (10cm) and leave it hanging loose.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 55 56

No comments

Baby Lock Enlighten BLE3ATW-2 Instruction Manual Page 45