Baby Lock imagine wave BLE3ATW Instruction Manual download pdf (Page 12)

Your Baby Lock Imagine Wave is equipped with an exclusive "Instant Jet-Air Threading System" for fast,

easy threading of the upper and lower loopers.

One push of the "Jet-Air" threading lever will automatically thread the loopers. It is no longer necessary to

use tweezers for threading the thread guides. If a looper thread breaks or runs out, just re-thread it. There

is no need to follow threading sequence.

1. Open the front cover.

2. Raise the presser foot to release all threads.

3. Depress the machine lock button firmly. Rot

ate the machine handwheel slowly toward you until the

button "snaps" into the locked position and the lock button release lever moves to the far lef

t (fig.A).

Note: The Imagine Wave must be in the locked position when threading the loopers unless otherwise

indicated. The machine in Locked Position also sets the needle position for using the Needle threader

This is also a safety feature when threading as the machine cannot sew while in locked position.

1. With the presser foot up and machine lock button in the locked position (fig. A) . Set the threading port

selector lever to "L" for lower looper threading (fig. B).

2. Place the thread cone or spool on the Lower Looper spool pin on the thread stand. Slip the thread into

the telescopic antenna thread guide "1" directly above the spool, snap into the thread guide "2" at the top

of the machine, through the slot on the front cover. (See fig. C page 11)

3. Pull 18 inches (40cm) of thread through guide "3". Insert the end of the thread into the threading port "L"

about 1 inch (2.5cm) . Use tweezers if necessary, to insert the thread end more easily.

4. Depress the looper threading lever (fig. D page 11) . If the thread does not go through the lower looper

eye with one push, depress the threading lever again until it does.

5. Clip the thread 4 inches (10cm) from the lower looper eye and leave it hanging loose.

6. Move the lock button release lever to the right.

Threading Your Imagine Wave

Locked Position for Threading

Lower Looper

Lock Button

Release Lever

Machine Lock

Button

Looper Threader

Selector

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

No comments

Baby Lock imagine wave BLE3ATW Instruction Manual Page 12